Cartridge gearbox removal
1 Remove the left cover. See “Left cover removal” on page 144.
2 Remove the four screws (A) securing the cartridge gearbox.
A
3 Disconnect the cable from the cartridge gearbox.
Duplex gear assembly removal
1 Remove the left cover. See “Left cover removal” on page 144.
2 Remove the rear door and cover. See “Rear door and cover removal” on page 206.
3 Remove the power supply. See “Power supply removal” on page 190.
4 Remove the power supply shield. See “Power supply shield removal” on page 191.
5 Remove the duplex. See “Duplex removal” on page 192.
6 Position the printer so that it sits on its right side.
7 Remove the E‑clip (A).
8 Remove the screw (B).
9 Remove the screw (C).
4514-220, -230
Repair information
158
To Next Page
Loading...
