Reduced Curl
When on, this setting significantly reduces throughput and should be activated only as a last resort to solve paper curl
problems. The printer uses this mode only when the media type is set to Paper.
Available options:
• Off
• On
PPDS Emulation
The value of this option determines if a printer can recognize and use the PPDS data stream.
Available options:
• Deactivate
• Activate
Demo Mode
Demo mode is often used in retail environments to highlight printer capabilities. The printer stores demonstration files
in the resident demo file of the base RIP firmware and in any supported optional memory devices.
When this mode is activated, the printer ignores all print jobs sent to it other than the demo file selected by the user.
Each demo file consists of one or more printed pages.
Available options:
• Activate—The printer boots into Demo mode after each power cycle.
• Deactivate—The printer boots into normal mode.
To print a demo file:
1 Activate Demo mode and then POR the printer.
2 Press to print the first demo job.
3 After the last page of the previous demo job has been printed, press to print the next demo job.
Auto CR after LF
This is used to select whether or not the printer automatically performs a carriage return after a line feed control
command. The Auto CR after LF is common to both the PPDS and PCL emulations. When the setting is changed, it is
changed for both emulations.
Available options:
• Off
• On
4514-220, -230
Service menus
121
To Next Page
Loading...
