Cont Prt Duplex Tray 2
Note: This appears only when Tray 2 is installed.
This initiates a continuous Tray 2 duplex print test. To stop the test, press X .
Par 1 Strobe Adj
This enables the user to adjust the amount of time the strobe is sampled to determine if valid data is available on the
parallel port.
Each time this value is increased by 1, the strobe is sampled 50 ns longer. Each time this value is decreased by 1, the
strobe is sampled 50 ns less. When the value of this setting is 0, the factory default value is used to determine the
amount of time the strobe is sampled.
Available options: ‑4 to 1
Print Event Log
This prints the Event Log. The Event Log tracks the occurrence of various critical events in the functional history of the
printer, such as paper jams and firmware updates.
Auto Dark Adj
This attempts to optimize the amount of toner used when printing with a specific operating point.
Available options:
• Disable
• Enable
Configuration menu
The Configuration menu group consists of menus, settings, and operations that are used to configure a printer for
operation.
Entering the Configuration menu
1 Turn off the printer.
2 Open the front access cover.
3 Press and hold .
4 Turn on the printer.
5 Release the button after 10 seconds.
4514-220, -230
Service menus
119
To Next Page
Loading...
