4 Close the rear and front doors.
5 From the printer control panel, press to clear the message and continue printing.
Sensor (fuser exit) jam service check
Action Yes No
Step 1
Check the input sensor area for jammed media fragments.
Is the paper path free of partially fed or jammed media?
Go to step 2. Clear the paper path of
any media fragments.
Step 2
Check the fuser exit sensor cable JEXIT1 for proper connection to the
controller board.
Is it properly connected?
Go to step 3. Reseat the cable.
Step 3
Check the fuser exit sensor for damage.
Is it free of damage?
Go to step 4. Replace the fuser. See
“Fuser removal” on
page 210.
Step 4
Check the fuser gears and rollers for damage.
Are they free of damage?
Go to step 5. Replace the fuser. See
“Fuser removal” on
page 210.
Step 5
Does the error remain?
Contact the next level
of support.
The problem is solved.
4514-220, -230
Diagnostic information
70
To Next Page
Loading...
