4-14 Service Manual
7100-XXX
Rear cover assembly removal
1. Remove the fuser assembly. See “Fuser assembly removal” on page 4-6.
2. Remove the transfer belt unit. See “Transfer belt unit removal” on page 4-5.
3. Remove the right cover. See “Right cover removal” on page 4-13.
4. Disconnect the rear cover assembly connector (A).
5. Remove the support pin (B), disconnecting the support cable from the MFP.
6. Remove two screws (C) from the rear cover assembly.
7. Slide the right side of the rear cover assembly away from the MFP until the hinge clears the slot.
8. Slide the rear cover assembly toward the right side until the captured end of the rear cover assembly
clears the mounting bracket.
9. Remove the rear cover assembly by pulling it away from the MFP.
A C
B
21
To Next Page
Loading...
