4-28 Service Manual
7100-XXX
6. Remove five screws (A) that secure the main drive gear assembly to the MFP.
7. Remove two screws (B) that secure the lower right frame.
8. Remove the main drive gear assembly from the MFP.
Note: When reinserting the main drive gear assembly, ensure that the bottom right corner is installed
before the lower right frame.
Waste toner feeder removal
1. Remove the main drive gear assembly. See “Main drive gear assembly removal” on page 4-27.
2. Loosen the two screws (A) of the sensor base to allow free movement of the waste toner feeder.
A
B
Note: screw
shown removed.
A
To Next Page
Loading...
