2-6 Service Manual
7100-XXX
User status messages
Message Description Action
Tray (1, 2) Missing The upper or lower tray is
missing.
install the upper or lower tray. If the problem
persists, see “Paper tray missing service
check” on page 2-30.
Toner Low (C,M,Y,K) The toner is low in the
cartridge indicated.
See “Toner low/empty service check” on
page 2-31.
Sleep The MFP is idle. These are the normal operating modes.
Please Wait The MFP is warming up.
READY The MFP is ready to
perform a task.
PC Printing The MFP is printing.
Calibrating The MFP is calibrating.
Connected to Server The MFP is connected to
a server for a push scan
job.
Sending File... A scan job is being
transmitted.
Send E-mail Notification An e-mail is being sent to
a user notifying them of a
push scan job being
completed.
Connection Fail Unable to connect to the
remote fax.
No Response The device
Busy The remote fax device is
currently busy.
Dial Failed The dial attempt to
another device failed.
Scanning Page The scanner is scanning
in the flatbed or ADF.
Job # Fax Job # is being
processed.
Dialing A fax number is being
dialed.
Awaiting Re dial The fax is between dialing
attempts.
Transmitting The fax is transmitting
data to another fax device.
Receiving The X502 is receiving fax
data from a remote fax
device.
To Next Page
Loading...
