4-22 Service Manual
7100-XXX
Waste toner bottle holder removal
1. Remove the right cover. See “Right cover removal” on page 4-13.
2. Disconnect the waste toner bottle holder connector (A).
3. Remove three screws (B) from the waste toner bottle holder. The bottom screw is longer than the other
screws.
4. Remove the waste toner bottle holder from the MFP.
Developer drive assembly removal
1. Remove the main motor assembly. See “Main motor assembly removal” on page 4-26.
2. Remove the waste toner bottle holder. See “Waste toner bottle holder removal” on page 4-22.
3. Remove four clips and the developer drive gears (A) from the inside of the MFP.
A
B
A
To Next Page
Loading...
