Lexmark X502N - Modem Speaker Removal; Fuser Fan Assembly Removal

Repair information 4-43
7100-XXX
5. Slide the left tray guide assembly out in front of the MFP.
Modem speaker removal
1. Remove the left rear cover.
2. Remove the top cover.
3. Disconnect the modem speaker cable from the system / RIP board.
4. Remove the old speaker from the interlock assembly by prying the speaker retaining tabs back, and
sliding the speaker out of the interlock assembly.
Fuser fan assembly removal
1. Remove the left rear cover. See “Left rear cover removal” on page 4-16.
2. Remove the top cover. See“Top cover assembly removal” on page 4-10.
3. Remove the system board. See “System board removal” on page 4-36.
4. Remove the screw (A) that secures the interlock assembly to the printer engine frame. Set the interlock
assembly aside.
A