Lexmark X502N - Scanner Assembly Removals; Flatbed Assembly Removal

Repair information 4-49
7100-XXX
Scanner assembly removals
Flatbed assembly removal
1. Remove the left rear cover. See “Left rear cover removal” on page 4-16.
2. Remove the RIP/System board cover. See “System board removal” on page 4-36.
3. Open the MFP rear cover.
4. Remove the screws (A) securing the upper left and right covers.
5. Remove the ADF unit. See “ADF unit removal” on page 4-53.
6. Disconnect the CCD ribbon cable, the operator panel cable, and the flatbed motor cable from the
system board.
A
A