4-38 Service Manual
7100-XXX
System board cage removal
1. Remove the left front cover. See “Left front cover removal” on page 4-15.
2. Remove the three screws (A) securing the engine card shield.
3. Remove the engine card shield.
4. Disconnect all the cables from the engine card.
5. Disconnect the modem speaker cable from the RIP card.
6. Remove the three screws (B) which secure the card cage to the printer frame.
7. Carefully remove the card cage from the printer.
Note: The engine controller board and system / RIP board do not need to be removed to perform this
removal.
To Next Page
Loading...
