To Next PageTo Next Page
Need help?Do you have a question about the Lifetime 1044 and is the answer not in the manual?
General| Brand | Lifetime |
|---|---|
| Model | 1044 |
| Category | Sports & Outdoors |
| Language | English |
Indicates special attention is needed when reading.
Indicates which parts are required for a specific assembly section.
Indicates which hardware is required for a specific assembly section.
Indicates which tools are required for a specific assembly section.
Indicates whether to use or not use an electric drill for a specific step.
Highlights the use of a centerlock nut for secure tightening.
Failure to follow warnings may cause serious injury, property damage, and void warranty.
Owners must ensure players know and follow rules for safe system operation.
Follow instructions carefully during assembly to ensure safety.
Use extreme caution when using a ladder for assembly steps.
Recommends two capable adults for safe and proper assembly.
Brick walls may not be sturdy; secure mounting through brick and into studs is critical.
Set pole height at 8'1" and orient mounting tube correctly.
Verify pole height to prevent Quick Adjust mechanism interference.
Install height stop hardware to prevent Quick Adjust hitting wall.
Insert the cap (ALM) into the mounting tube (FKE).
Secure saddle brackets with hardware and attach U-bolts.
Slide assembly onto pole to 8'1" height without using height stop.
Slide assembly onto pole to 8'6" height using height stop.
Verify wall height to prevent Quick Adjust II mechanism interference.
Install height stop hardware to prevent Quick Adjust hitting wall.
Attach 2x4 boards to wall studs at specific heights as template.
Insert cap into mounting tube and attach wall brackets securely.
Secure wall mounting brackets to backboard using lag screws.
Slide U-bolt through brackets; fold inner guard and secure brackets.
Set rim support channel, secure U-bolt ends through backboard and rim.
Attach rim to backboard using bolts, nuts, and channel.
Bend brackets outward, align holes, secure with bolts and nuts.
Fold outer guard and set dunk latch into it.
Slide dunk latch, attach lower extension arms with hardware.
Attach upper extension arms to brackets and Quick Adjust mechanism.
Slide U-bolt through brackets; fold inner guard and secure brackets.
Attach rim hardware using bolts, washers, and T-nuts.
Attach brackets to rim assembly, thread jam nuts onto U-bolt ends.
Slide compression springs and retainer plate over U-bolt ends.
Secure retainer plate with nuts; bend backboard brackets outward.
Secure backboard brackets with screws; fold outer guard and set dunk latch.
Slide Quick Adjust mechanism between guards; align holes.
Secure extension arms to backboard brackets and Quick Adjust.
Identify metal frame backboard and rim types (Slam-it®, Slam-it® Pro).
Assemble pivot, insert bolts through rim and housing.
Press push nuts onto axle; slide finger guards over bolts.
Slide U-bolt through brackets; fold inner guard and secure brackets.
Attach extension arms to backboard bracket with spacer and bolt.
Slide spacer and extension arm onto bolt; secure with nut.
Attach remaining arms with larger/smaller bolts and nuts.
Peel protective film from backboard; install center frame pad.
Secure left and right corner frame pads to the frame.
Mount backboards to pole tube using spacers and bolts.
Mount backboards to wall using spacers and bolts.
Use a broomstick to adjust the rim height up or down.
Keep hands away from moving parts, use caution, wear mouth guard.
Check for loose hardware, wear, and corrosion; take preventive measures.
Replace parts showing excessive wear or damage; contact customer service.
Follow warnings for safety; avoid misuse, keep hands clear of moving parts.
Register product online for feedback, notifications, and recall information.
Warranty covers defects in material/workmanship for five years; excludes misuse and accidents.
Submit claims in writing with sales receipt and photos of damaged parts.
Register product online or by phone for faster customer service.
