Unpack, Inspect and Install
248083387-1 Rev 10 3-3
Accessories Several accessories may be ordered to tailor the instrument to the user
needs and should be readied for use at this point.
• Temp/RH Wand (optional) - plugs into the instrument’s rear panel.
The 4-20mA probe monitors temperature (0° to 150° F or -17.8° to
65.6° C) and relative humidity (0% to 100%). Results are
displayed, printed (if printer is available) and can be downloaded to
the LMS XChange software for backing up and historical data
review.
• Air Velocity Probe (optional) - plugs into the instrument’s rear
panel. The probe monitors air velocity up to 200 feet/minute (1.016
m/sec). Results are displayed, printed (if printer is available) and
can be downloaded to the LMS XChange software for backing up
and historical data review.
• Differential Pressure Sensor (optional) - plugs into the
instrument’s rear panel. Monitors range from 0 - 0.5" H
2
O (124.5
Pa). Results are displayed, printed (if printer is available) and can
be downloaded using the LMS XChange software for back ups and
historical data review.
• Isokinetic Sampling Probe (standard) - for use in unidirectional
air flow to maximize correlation between counts and actual
particle-size distribution. Can also be hand-held for particle
counting in specific locations.
• Shipping Case with Wheels (optional)
• Internal Printer (optional)
• Printer Paper (2 rolls; optional)
• Cleanroom Printer Paper (optional, must be ordered in quantity
of 10 rolls or more)
• Validation Documentation (optional)
• Li-Ion Battery, removable and rechargeable, single or dual
(optional)
• Cleanroom Cart (optional)
• USB “A to B” Communication Cable (standard)
• USB to RJ-45, RS-485 Serial Adapter (optional)
• USB to RJ-45, RS-232 Serial Adapter for laptops that have only a
USB port and do not have a 9-pin serial port for communications
(optional)
To Next Page
Loading...
