Lightware HDMI20-OPTC series - Querying the DHCP State; Changing the DHCP State; Enabling Ethernet Port; Port Configuration


 HDMI20-OPTC series – User's Manual 51
Querying the DHCP State
Command and Response
Ý 
Ü 
Example
Ý 
Ü 
Changing the DHCP State
Command and Response
Ý 
Ü 
Example
Ý 
Ü 
Enabling Ethernet Port
Command and Response
Ý 
Ü 
Example
Ý 
Ü 
Disabled the P2 Ethernet port.

Querying the RS-232 Operation Mode
Command and Response
Ý P1.Rs232Mode
Ü 
Parameters
0: Pass-through
1: Control (local)
2: Command injection (local)
Example
Ý 
Ü 
Setting the RS-232 Operation Mode
Command and Response
Ý 
Ü 
Parameters
See the previous legend.
Example
Ý 
Ü 
Setting the BAUD Rate
Command and Response
Ý 
Ü 
Parameters

Parameter
description
Parameter values
 Baud rate value 0: 4800; 1: 7200; 2: 9600; 3: 14400; 4: 19200; 5: 38400; 6: 57600; 7: 115200
Example
Ý 
Ü 



