Lightware HDMI20-OPTC series - Sending Message Via UDP Port


 HDMI20-OPTC series – User's Manual 54
Sending Text Message
The command is for sending a text message in ASCII-format.
INFO: Escaping will not be processed using the tcpText command.
Command and Response
Ý :)
Ü 
Example
Ý 
Ü 
Sending Binary Message
The command is for sending a binary message in HEX format.
Command and Response
Ý :)
Ü 
Example
Ý 
Ü 
Sending Message via UDP Port
The device can be used for sending a message to a certain IP:port address. The three different commands
allow controlling the connected (third-party) devices.
Sending UDP Message
The command is for sending a command messages in ASCII-format with an option for escaping special
characters.
Command and Response
Ý :)
Ü 
Example
Ý 
Ü 
Escaping in the Message

then they need to be escaped. You can use the following format for escaping:
<command
1
><\x0d\x0a><command
2
><\x0d\x0a>...<command
n
><\x0d\x0a>
See more details in Escaping section.
Sending Text Message
The command is for sending a text message in ASCII-format.
INFO: Escaping will not be processed using the udpText command.
Command and Response
Ý :)
Ü 
Example
Ý 
Ü 
Sending Binary Message
The command is for sending a binary message in HEX format.
Command and Response
Ý :)
Ü 
Example
Ý 
Ü 



