Maintenance 5
Recommendations for consumables
Inspection and maintenance data
Unit Devices / Consumables
Filling quantity / Set values
Engine Engine oil
approx. 4.5 l
Fuel tank Diesel
approx. 70.0 l
with heating system / air
conditioning: approx. 10.0 l
Cooling system Coolant additive / drinking
water
without heating system / air
conditioning: approx. 8.5 l
Hydraulic system Hydraulic oil
approx. 27.8 l
Battery
Distilled water
As required
Tyres
Pneumatic
See sticker on inside of
overhead guard
front: 425 Nm
Wheel fastenings
Tighten
rear: 640 Nm
Load chains / Lift mast
channels
Linde chain spray As required
Air conditioning
Refrigerant
1600 grams
Recommend
ations for consumables
Diesel fue
l
Only diesel fuels to EN 590 with a cetane
number (CN) not lower than 51 may be used.
The fuel sulphur content must not exceed
350 mg/kg.
If the only diesel fuel available has a sulphur
content of more than 350 mg/kg, the engine oil
change intervals must be reduced as follows:
•Atasulph
ur content more than 350 mg/kg
and less
than 2000 mg/kg = engine oil
change i
nterval 300 operating hours.
• At a sulphur content more than 2000 mg/kg
= engine oil change interval 150 operating
hours.
NOTE
As the ambient temperature falls, the fluidity
of the diesel fuel is reduced due to paraffin
segregation. If "summer" diesel fuels are used
at low ambient temperatures, this can lead to
malfuncti
ons. For this reason, cold-resistant
"winter" d
iesel fuel is available during the
colder par
t of the year, which can reliably be
used at te
mperatures down to about -22°C.
In winter, use only winter diesel fuel, so that
the fuel lines do not become blocked by
segregated paraffin. At very low temperatures
even winter diesel fuel can suffer from this
problem of segregation. Please contact your
authorised dealer.
CAUTION
Several important points must be observed for the
use of bio-diesel fuel (RME according to EN 14214).
Please contact your authorised dealer.
Hydraulic oil
NOTE
The working temperature is the critical factor
to be considered when selecting the correct oil
Operating Instructions – 394 807 10 01 EN – 07/2011 105
To Next Page
Loading...
