Linde H40D - Lift mast, lift mast chains, lift cylinder and end stops: Check mounting, condition and function; Adjusting the lift mast chain; Standard lift mast

5 Maintenance
Hydraulics
Hydraulics
Change hydraulic oil
Drain hydraulic oil
ENVIRONMENT NOTE
Observe information regarding working with
consumables.
¾ Drive truck over pit.
¾ Fully lower fork carriage and lift mast.
¾ Place a collection vessel under the left side
of the truck floor.
¾ Open the bonnet. Unscrew the breather (2)
with dipstick (3).
1
d3921335
¾ Unscrew hydraulic oil drain plug (1) on
hydraulic oil tank.
¾ Allow all oil to drain off.
¾ Clean area around oil drainage location
thoroughly.
¾ Refit drain plug.
Tightening torque: 25 Nm
174 Operating Instructions – 394 807 10 01 EN – 07/2011