2 Safety
Instructions for fitting attachments
There is a recommendation setting out the
scope of the periodic safety inspection —FEM
4.004 of the European Industrial Truck Asso-
ciation— which defines a test log to document
the current safety inspection and an inspection
sticker for the next safety inspection. The next
safety inspection date is shown by the year
number (3) on an adhesive label (2), which
changes colour every year and is found on a
label (1).
The scope of the safety inspection is added
by the manufacturer in accordance with
the specific truck type. Please ask your
authorised dealer to carry out this work.
Diesel engine emissions
Diesel engine emissions i
nclude carcinogenic
hazardous materials. The
se should not be
allowed to infiltrate the a
ir in workplaces.
If trucks with diesel engines are used in fully
or partially enclosed spaces, this must first be
reported to the relevant occupational health
and safety authorities. Operating instructions
must be displayed in the working areas.
The national regulations must be observed
without fail.
Checking the particle filter system
Particle filter syste
ms must be maintained
and tested every 6 mon
thsbyacompetent
person. The test resu
lts must be recorded and
enclosed with the rep
ort book. Observe the
national regulation
s for your country.
Instructions for fi
tting attachments
To depressurise th
e oil in the lines before
fitting an attachme
nt, the hydraulic system
for the auxiliary h
ydraulics can be connected
using an accumulat
or (Special equipment)
depressurised
See the section entitled "Depressurisation".
WARNING
Improper handling of the accumulator may lead to
serious injuries.
Before starting work on the accumulator, it must be
depressurised. Contact your authorised dealer.
14 Operating Instructions – 394 807 10 01 EN – 07/2011
To Next Page
Loading...
