1 Introduction
Receiving the industrial truck
• Maintenance-free storage of the lift mast
and tilt cylinder via rubber-cushioned
linkage points
• Electric tilt angle limitation.
Electrical system
The electrical system is powered by the
three-phase alternator with 12 V DC voltage. A
12 V battery with 88 Ah is installed for starting
the engine. It is located under the driver’s seat
in the engine compartment.
Truck operation when using a shovel
When operating the truck with a shovel, stall
protection can be activated by your authorised
dealer.
In this case, extreme load
ing of the drive
engine due to the associa
ted engine speed
decrease leads to a sligh
t delay in executing
the working hydraulics.
NOTE
For a period of extended l
oading of the
engine, the joystick mus
t be switched to the
zero position in order t
o release the working
hydraulics again.
Receiving the industr
ial truck
Before the industrial
truck leaves our factory,
it undergoes a thoro
ugh inspection process in
order to guarantee t
hat it is in perfect condition
and that it contains
all of the equipment
specified in the orde
r.
In order to prevent complaints from occurring
further down the line, the exact condition
of the industrial truck and the integrity of
the equipment are checked and the proper
handover/acceptance of the truck is confirmed
by the dealer.
NOTE
In trucks that lea
ve our factory without a lift
mast, an addition
al stop screw for speed li-
mitation is locat
ed under the reverse accelera-
tor pedal (dual-
pedal operation) or under the
accelerator pedal (si
ngle-pedal operation).
This must be removed
after installing the lift
mast; see the sectio
n entitled Driving without
aliftmast.
The following techn
ical documents belong to
each industrial tru
ck:
• Operating instructions for the truck
• Operating instructions for the attachment
(only applies to trucks delivered from the
factory with an attachment)
• EC declaration of c
ompliance
• Safety rules for the use of industrial trucks
(VDMA)
• Registration document for the industrial
truck, which is issued by authorised dealers
as part of the handover.
6 Operating Instructions – 394 807 10 01 EN – 07/2011
To Next Page
Loading...
