5 Maintenance
Hydraulics
¾ Unscrew the breather filter (1) with oil
dipstick on the left side of the vehicle.
NOTE
Tank under low pressure. A small amount of
air will escape.
¾ Wipe the oil dipstick with
a clean cloth.
¾ Screw the breather with dipstick (2) in
completely and then unscrew it again.
The oil level should be between the two marks
(3) on the dipstick (2).
¾ Top up the hydraul
ic oil to the upper mark if
necessary.
Difference in quantity between max. and min.
marks: approx. 3 l
Hydrauli
c system: changing the filter
Feed and p
ressure filter
ENVIRONMENT NOTE
Observe information regarding working with
consumables.
¾ Unscrew the side maintenance cover on the
left.
176 Operating Instructions – 394 807 10 01 EN – 07/2011
To Next Page
Loading...
