Linde H40D - Page 297

Circuit diagrams 7
Wiring diagram
Arrangement
I LPG volume display for volumetric filling
(2 x 36 l) with shut-off valve (only with LPG
version)
II Changing particle filter (diesel version only)
III Camera system
Legend
7A2 Changing particle filter controller, 578–590
9A5 Monitor, 607-617
B1 Tank transmitter (volumetric filling), 563
7B3 Changing particle filter buzzer, 591
9E6 Camera 1, 607-609
9E7 Camera 2, 612-614
F15 10 A fuse, 582, 607
7F4 2 A fuse, 588
7H4 Indicator light (orange), 588
7S3 Changing particle filter,switch 577–578
7S4 Changing particle filter pressure switch,
582–583
X6 5-pin plug connector (for main harness),
563, 567
X10 18-pin plug connector (for basic equipment),
578, 582, 607, 614
7X6 9-pin plug connector (changing particle
filter), 578, 582
7X7 3-pin plug connector (reset switch), 577.
578
7X8 2-pin plug connector (pressure switch), 582,
583
9X26 5-pin plug connector (camera system),
607-609
9X27 5-pin plug connector (camera system),
612-614
9X28 5-pin plug connector (camera system),
607-609
9X29 5-pin plug connector (camera system),
607-616
1Y12 Tank shut-off valve, 567
1Y13 Tank shut-off valve, 570
Wire colours
BK Black
BN Brown
BU Blue
GN Green
GY Grey
OG Orange
RD Red
VT Violet
WH White
YE Yellow
The number in front of the wire colour refers
to the wire cross-section.
Wires with unspecified cross-section = 0.75
mm
2
Notes
(a) Wiring diagram basic equipment (only with
LPG version)
(b) For electronic controller N1:K29
*1) Switch opens when the changing particle
filter is fitted and the cover is closed (diesel
version only)
*2) Switch is shown in the pressure differential
OK position (only with diesel version).
Operating Instructions – 394 807 10 01 EN – 07/2011 285