Operation 4
Standard equipment
NOTE
Theforklifttruckcanonlybed
riven with the
driver’s seat under load.
¾ Start the engine.
¾ Slightly raise fork arms and tilt lift mast back.
¾ Release the parking brake (
unlock the park-
ing brake lever (1) and move
it downwards
as far as the stop).
Forwards travel
¾ Carefully operate the right accelerator pedal
(2).
The driving speed of the truck increases as the
actuation distance of the pedal increases.
NOTE
Pressing down the acce
lerator pedal hard is
to no advantage as the m
aximum acceleration
rate is controlled au
tomatically.
Reverse travel
¾ Carefully operate the left accelerator pedal
(4).
The truck will reverse slowly or quickly de-
pending on the accelerator pedal position.
Changing direction of travel
¾ Release accelerator pedal pressed.
The hydrostatic drive will act as a service
brake.
¾ Press the accelerator pedal for the opposite
direction of travel.
The forklift truck will now accelerate in the
specified direction.
¾ Both feet should be left on the accelerator
pedals so that the truck is easily controlled
in every driving movement.
The accelerator pedals can be switched over
directly. The hydrostatic drive brakes the
truck until it comes to a standstill and then
accelerates in the opposite drive direction.
Operating Instructions – 394 807 10 01 EN – 07/2011 47
To Next Page
Loading...
