4 Operation
Standard equipment
brisk speed. The engine will quickly reach its
operating temperature.
Switching off the engine
CAUTION
For engines with a turbocharger, the high speed
of the turbocharger shaft (approx. 100,000 rpmat
full load) could cause the shaft bearing to run dry
through lack of lubrication, thus damaging it.
Do not switch off the engine when under full load,
instead allow it to run on for a few minutes at low
speed.
¾ Remove foot from accelerator pedal (3).
¾ Move the direction selection lever (4) into
the neutral position.
¾ Turn the switch key (2) to the zero position.
NOTE
The brake is applied when the engine is
switched off.
¾ Turn the parking brake lever (1) in a clock-
wise direction until it engages.
¾ Remove the switch key (2) when leaving the
truck.
52 Operating Instructions – 394 807 10 01 EN – 07/2011
To Next Page
Loading...
