Operation 4
Special equipment
Switching on the interior lighting
¾ Press toggle switch (1).
Switching on the lighting.
¾ Move toggle switch (2) to cent
re position.
The sidelights and licence
plate light are
switched on.
¾ Switch toggle switch (2) as far as it will go.
The dipped beams, sidelights and licence
plate lights are switched on.
Switchingontheworkingspotlights.
¾ Press toggle switch (3) or (4) (depending on
the version).
Switching on the hazard warning system
¾ Press toggle switch (5)
.
Switch on rotating flas
hing light
Depending on the equipment there are two
different versions.
Version 1 (single stage switch):
¾ Press toggle switch
(6).
The rotating flashing light is always switched
on.
Version2(twostageswitch):
¾ Move toggle switch
(6) to centre position.
The rotating flashing light is switched on only
when reversing.
¾ Switch toggle switch (6) as far as it will go.
The rotating flas
hing light is always switched
on.
Operating Instructions – 394 807 10 01 EN – 07/2011 73
To Next Page
Loading...
