Operation 4
Special equipment
¾ Press the
*
(4) button to start the input
device.
The green LED (2) flashes.
¾ Enter personal PIN (factory se
tting =
0 0
0 0 0
) and status code.
Therefore, for a properly set-up truck, the PIN
should be as follows:
0 0 0 0 0 0
.
NOTE
If the PIN was input incorrectly, press the
*
button (4) and enter the correct PIN.
¾ Confirm the entry with the
#
button (3).
The green LED (2) lights u
p with a steady light.
NOTE
If the red LED (1) lights up, an incorrect PIN
was entered. Press the
*
button (4) and enter
it again. If more than three incorrect entries
are made (factory setting), the red LED (1)
lights up and the green LED (2) flashes. The
input of a valid PIN is blocked for 10 minutes.
The blocking time can be interrupted by
inputting a special PIN. Please contact your
fleet manager.
¾ Rotate the turning kn
ob (6) clockwise to the
stop and start the tru
ck.
NOTE
If the truck does not start properly the first time,
the starting procedure can be repeated until
the turning knob (6) is returned to the zero
position, and the PIN is discarded after expiry
of the delay time.
NOTE
If the green (2)
and red (1) LEDs both light up
as steady light
s, the data must be read out.
Please inform y
our fleet manager at once.
Operating Instructions – 394 807 10 01 EN – 07/2011 83
To Next Page
Loading...
