LineEye LE Series User Manual

-26-
3.4 Frame End Setting
Set the time/data of non-communication state which is recognized as
a frame end. This setting is necessary to have an accurate time stamp
→ 3.6 Idle Time and Time Stamp
Press [Menu] → [Configuration] and set [Frame end time] using numeric
keys.
■
Frame End Time
Set the frame end time in
1-100ms. Initial setting is 5ms.

Denition of frame is dierent in each application. If you nd a time stamp in
the middle of one frame, try to set a bigger amount in the “Frame end time”.
If you cannot find any time stamp, try to set a small about in “Frame end
time”
■
Frame End Data
Set the frame end data in Hex
using [0]-[F] keys.
Initial setting is “none”.

Frame end data can be set in maximum two characters and able to set don’t
care using “x”.
For example, set “03”,“x” if frame end data is “03” plus BCC (frame check
code).

LineEye LE Series Specifications

General

Brand	LineEye
Model	LE Series
Category	Measuring Instruments
Language	English