LineEye LE Series User Manual

-14-
1.5 Power and Battery

USB Bus Power
Supply power from a PC, or USB charger (option).
Connect attached micro USB cable to the USB device port of line monitor.
Attention:
Do not use the USB charge which outputs 9V or 12V. (use 5V only)
Batteries inserted in the line monitor are used when USB bus power is OFF.
However, do not remove the batteries from the line monitor while using with
USB bus power.

Battery Drive
LE-110SA/120SA is able to run for about 5 hours with attached Ni-
MH batteries. For temporary use, it is able to use AA-size Alkali
batteries (LR6) and run for about 2 hours.

The running time is just a standard time. It might be dierent if using batteries of
dierent manufactures.
＜
Attention for Alkali batteries
＞
Please follow the instruction. It may cause leaking and damaging the
batteries.
* Use Alkali batteries for temporary use. Put back the Ni-MH batteries for
normal use.
* Do not use old and new batteries together at the same time. Do not use the
batteries of dierent manufactures.
* Change the batteries immediately if remaining quantity of batteries is
low.
* Do not charge the Alkali batteries.
* Do not touch the liquid of batteries directly. Please go to see your doctor
when having it on your body.
Micro USB cable
USB port
USB battery charger (not included)
Micro USB cable

LineEye LE Series Specifications

General

Brand	LineEye
Model	LE Series
Category	Measuring Instruments
Language	English