-53-
■
Timer control
It starts, stops, or restarts from 0
the specied timer.
■
Counter control
It adds 1(increment) to or clears
to 0 the specied counter.
■
Trigger control
It makes the specified trigger
factor valid, invalid, or inverts the
status of it.
■
Transmit data
It transmits the specified send
table data of a pre-set data after
the time specified at “response
time” (0 to 9999m seconds.)
This function is valid for
simulation mode only.
→ Chapter 6 Simulation Function
The next transmission process will be ignored until the current transmission
nished.