42/150 D9U001GKB-0101
Sliding the manipulation wheels in
1) Drive the chair up (watch electric cables under the base)
2) The wheels automatically hide and the base is inclined to the original
position. The signal for secure sliding the wheels in and setting up the base
is an audible click together with the sliding out of the button for sticking the
manipulation wheels out.
3) Memory functions do not operate with manipulation wheels sliding out.
It is forbidden to use the chair with manipulation wheels sliding out.
4.5.2 Without integrated wheels
Correct transport position of the chair
1) The chair is in the lowest position (minimum column height)
2) Footrests must be set up as low to the ground as possible.
If the two above mentioned conditions are kept, the chair can be held by
the footrests and the back part and it can be moved. During manipulation
the chair needs to be lifted. The chair may not be shoved so that
safeguard of the switch placed underneath in the centre of the chair frame
is not damaged.
Improper position of the chair
Moving the chair by grasping the footrests, which are not in the lowest
position in relation to the ground, can cause permanent damage of the
column covers, which makes the chair unserviceable.
To Next Page
Loading...