84/150 D9U001GKB-0101
5.5.1 Activation of wired connection to an existing network
1) Open the Internet browser.
2) Type //c-XXXXXXXXXXX in the address bar, where XXXXXXXXXXX is the
serial number on the nameplate of the Gracie chair.
or type //c-XXXXXXXXXXX.local in the address bar, where XXXXXXXXXXX
is the serial number on the nameplate of the Gracie chair
or type IP address (10.0.0.1) of the GRACIE chair into the address bar
When typing the path into the address bar, make sure to use correct
slashes!
3) Press ENTER on the keyboard of your PC/MAC or click on "Go" on the
address bar.
4) You will enter the settings page of WLAN module of the GRACIE chair.
Verification of connection may take from two to three minutes. It depends on
the operation system of your PC/MAC.
To Next Page
Loading...