D9U001GKB-0101 57/150
Maintenance and cleaning
• A regular yearly inspection of this medical equipment must be carried out.
Maintenance of the screen
• Disconnect the screen and chair from power supply before cleaning.
This will prevent accidental pressing of buttons on the control panel.
• Clean the screen cover and control elements with a soft cloth slightly
moistened in water with detergent. Do not use an abrasive sponge,
cleaning powder or solvents like alcohol or gasoline!
• Prevent any contact with water!
• Do not touch, scratch or tap the screen with sharp objects like a pencil
or screwdriver. Such contact may lead to scratching of the surface.
• Do not insert sharp objects or pour liquid into the openings in the
screen. It could cause accidental fire, electric shock or failure.
• Connection of any other device is not possible!
• Do not attempt to repair the device by yourself. By opening the cover
you may expose yourself to dangerous voltages or other possible
risks.
• Do not place the screen near heat sources such as radiators or to
places exposed to direct sunlight, places with high dust generation or
near sources of mechanical vibrations or shocks.
• When the chair is connected to the network and the screen is in sleep
mode, a LED diode is flashing.
4.14 Digital Videocolposcope
The colposcope is supplied 12 V DC from a power supply placed in the chassis.
The power supply is powered from the mains by the chair's power cable.
To Next Page
Loading...