11
No modification of this equipment is allowed.
2.1 Safety Instructions
Follow the instructions carefully.
Only use the bed if it is in perfect working order.
If necessary, check the bed functions daily or at each shift change.
Use the bed only with the correct mains supply.
Ensure that the bed is only operated by qualified personnel.
Ensure that the patient (health permitting) has been informed about the operation of the bed and all
applicable safety instructions.
Move the bed only on even, hard-surfaced floors.
Replace any damaged parts immediately with original spare parts.
Ensure that maintenance and installation are performed only by qualified personnel trained by
the manufacturer.
Do not apply excess weight or loads to the bed according to SWL (safe working load).
During peak loads or unavoidable excess loads (CPR), place mattress platform in the lowest position.
Ensure that only one adult patient uses the bed at any time.
Take care to avoid injuries or squeezing when operating moving parts.
When using lifting poles or infusion stands, ensure that nothing will be damaged when you move or
adjust the bed.
Ensure that the castors are locked when the bed is occupied.
Keep the mattress platform in the lowest position at any time when the healthcare personnel are not
trea- ting the patient in order to prevent the patient from falling or injuries.
Ensure that siderails are operated only by healthcare personnel.
Never use the bed in areas where there is a hazard of explosion.
Enable or disable functions on patient controls using the supervisor panel as appropriate for the
patient’s physical and mental state. Verify that the function is actually disabled.
Never handle the mains plug with wet hands.
If this equipment is modified, appropriate inspection and testing must be
conducted to ensure continued safe use of the equipment.
Do not modify this equipment without authorization of the manufacturer.
During specific investigations or treatments the significant risks of reciprocal
interference posed by ME equipment may occur.
An additional multiple socket-outlet or extension cord shall not be connected
to the medical electrical system.
To Next Page
Loading...
Need help?
General
