LINET Multicare LE User Manual

23
8.1.3 Cover
A two part cover encloses the mattress decks and consists of:
A top cover of two-way stretch, waterproof and vapour-permeable, polyurethane coated nylon, fitted with a flap to
cover the 360-degree interchangeable zip.
A base cover of heavyweight non-stretch PVC coated polyester, fitted with a quick release securing strap, to
prevent the mattress shifting if the head or foot boards are removed. Two re-positioning straps are also fitted
either side of the base cover, to aid repositioning of the mattress along the bed platform if necessary.
8.2 SCU (System Control Unit)
The SCU (System Control Unit) is installed under the leg section of the bed frame. It is possible to
have the Multicare LE bed delivered with the SCU factory-fitted, or to have it retrofitted by
approved service personnel. The SCU is equipped with 2 air connector sealing plugs.
 Connect sealing plugs to SCU air outlets to prevent any ingress of dirt or fluids.
Connection
Multicare LE is equipped with a dedicated power outlet at the auxiliary power distribution point.
 Connect SCU to power outlet using its integrated power cord If the Symbioso mattress has been
removed from the Multicare.
Control
The SCU is operated via the Multiboard controls.
NOTE When removing the air mattress, it is sufficient to switch off the SCU using the ON/OFF
switch on the side (see Transport Mode/Power Failure).
Alarm system
The SCU is equipped with a comprehensive alarm system which detects any problems with the
system perfor- mance.
The alarm system
 gives audible and visual alarms via the Multiboard if a problem requires immediate action.
 stores information for the service personnel to review later.
8.1.1 Replacing the mattress
When replacing the Symbioso mattress by a standard mattress, it is necessary to remove Symbioso.
 Switch OFF the SCU.
 Remove Symbioso.
 Place standard mattress on bed.
NOTE Disconnect the two mattress air pipes from the SCU, then put sealing plugs into air outlets before
removing the Symbioso and fitting the standard mattress.
Mattress damage due to incorrect handling!
 These straps are not designed for lifting the mattress with the patient
on the mattress, or for emergency evacuation.
Caution
Mattress damage due to incorrect handling!
 The top cover flaps must not be used to reposition the mattress along
the bed platform, or for any lifting purposes.
Caution

LINET Multicare LE Specifications

General

Brand	LINET
Model	Multicare LE
Category	Medical Equipment
Language	English