25
1
Fig. 9 Power Switch
Switch on SCU using illuminated power switch 1 at back of SCU box.
1 2
Fig. 10 Selection Button
Press CLP button 1 or Max inflate button 2 to start the mattress inflating.
Mattress starts to inflate in selected mode.
NOTE When switched on, the SCU will return to the last mode (MAX or CLP) and pressure setting. The mode
and pressure settings are only valid when the SCU has been running with these settings for more than 5 minutes.
During the inflation process:
Indicator 1 or 2 flashes yellow, depending on the last mode setting.
When the set pressure level is reached, indicator 1 or 2 will remain solid on.
The inflation process can take up to 15 minutes with a fully deflated mattress.
Risk of pressure sores creation due to insufficient air in mattress!
Symbioso must be inflated before patient is placed on mattress
To Next Page
Loading...
Need help?
General
