LINET Multicare LE User Manual

47
11.10.9 Protector
The Protector is an optional accessory for the Multicare LE bed. The main purpose of the Protector is to reduce the
risk of patients falling off the bed.
The Protector is not included in the standard bed equipment and must be ordered separately. The Protector can be
used with expanded or standard beds.
1.
Inserting the Protector into the casing in the protective ring on the corner
2.
The Protector inserted in the casing
3.
The fixing element attached to the telescopic profile of the bed extension
4.
The Protector attached to the Multicare bed (The Protector can also be used on expanded beds.)
Attach the Protector to the bed as follows:
 Insert the Protector pin into the casing in the protective ring at the corner of the foot end of the bed (1).
 Ensure that the fixing element is secured to the telescopic profile of the bed extension (3).
Remove the Protector from the bed as follows:
 Grasp the upper end of the Protector.
 Remove the Protector from the casing.
WARNING!
Risk of injury due to the patient falling off the bed!

Ensure that the Protector is installed securely.

Always check that the side rails are properly locked.
Fig. 32 Protector

LINET Multicare LE Specifications

General

Brand	LINET
Model	Multicare LE
Category	Medical Equipment
Language	English