LINET Multicare LE

68
Type of Cleaning
Parts to be cleaned
Routine Cleaning and Disinfection
 exposed mattress parts
 exposed SCU parts
Full Cleaning and Disinfection
Due to the variety of laundry equipment, chemicals and conditions in use, customers should satisfy themselves
through pre-testing. It is essential that articles be thoroughly rinsed and dried after all cleaning procedures and
before storage or reuse. Wet or damp PU surfaces are more prone to mechanical damage than when dry.
As stated above, after application of a suitable cleaner, the surface must be rinsed with water and dried before use.
(Even if the cleaner instructions say that this is not required). This prevents a build up of chemicals on the mattress
surface which could be reactivated during use and affect biocompatibility. The High MVP Coating may swell and
change appearance during cleaning. This will recover after being thoroughly dried.
NOTE: Continued use of high concentration, chlorine-based disinfectants may significantly reduce the
performance and the working life of a coated material.
 exposed mattress parts
 exposed SCU parts
 internal parts of mattress
 internal parts of cover
22.3.2 Routine Cleaning and Disinfection
Cleaning the mattress:
 Check mattress cover top for any signs of damage.
Replace or repair and completely disinfect mattress cover top if damaged.
 Check inside of mattress cover top for signs of liquid ingress.
Replace or clean and completely disinfect mattress cover top if damp inside.
 Leave mattress cover on mattress.
 Clean with 60 °C warm water and cleaning detergent.
 Rinse mattress with cold water.
 Let mattress dry or wipe dry.
 Wipe mattress with disinfectant.
 Rinse mattress with cold water.
 Let mattress dry or wipe dry.
Cleaning the SCU:
 Wipe SCU with disinfectant.
 Let SCU dry or wipe dry.
22.3.3 Full Cleaning and Disinfection
Cleaning the mattress:
 Deflate mattress and remove cover (see Removing the Mattress Cover).
 Check mattress cover top and base for any signs of damage.
Replace or repair and completely disinfect mattress cover top and base if damaged.
 Check mattress cover top and base for signs of liquid ingress.
Replace or clean and completely disinfect mattress cover top and base if damp inside.
 Clean all mattress cells and pipes with 60 °C warm water and cleaning detergent.
 Rinse mattress with cold water.
 Let mattress dry air dry or wipe dry.
 Wipe mattress with disinfectant.
 Rinse mattress with cold water.
 Let mattress dry air dry or wipe dry.