96 CHAPTER 7: MAINTENANCE
QUICK LOAD SERVO 80 S2
1. MAINTENANCE
Please read the safety instructions provided at the beginning of this manual before handling
the following devices.
Batteries
In the event of a power failure, a backup battery saves the data contained in the SERVO amplifier. It is
possible that with time this battery will slowly drain; in this case a message will be displayed on the remote
control. The battery must be replaced as soon as possible with a battery of the same type.
Switching power off when the message “Battery low” could lead to loss of parameters. Don’t
switch the power until the battery has been replaced.
Cleaning
As with any vehicle, machinery, or device, regular cleaning of your bar feed system can only serve to
improve its operation and prolong its useful life.
For cleaning on the outside, use a soft cloth and a regular detergent, for the inside, use a cloth or a brush.
However, make sure that the rollers and parts made of synthetic materials do not come into contact with
these products.
The use of compressed air for cleaning is not advisable, because particles could become lodged in sensitive
areas and impede the proper operation of the bar feed system.
At no time should solvents, such as acetone, or diluents be used for cleaning the bar feed
system. At no time should cleaning products come into contact with electrical components.
Spare parts
Without the written consent of LNS SA, no addition or modification of the machine or spare parts
can be undertaken.
LNS SA assumes no responsibility when using spare parts which were not provided by LNS SA.
To Next Page
Loading...
