72 CHAPTER 6: OPERATION
QUICK LOAD SERVO 80 S2
5. SETTINGS
Please read the safety instructions provided at the beginning of this manual before
handling the following devices.
Description
The QUICK LOAD SERVO 80 S2 has several parameters and functions allowing the operator to configure
it so that it adapts as closely as possible to the lathe on which it is installed, as well as to the production
mode under way.
The position of the flag, or the quantity of material left to be machine, can be known at any time by checking
the remote control.
The pushing torque of the motor is automatically selected according to the bar stock diameter.
The height of the loading table and the slope of the loading fingers are also automatically set.
When hexagonal or squares bars must be loaded, the servo motor intelligently manages the loading into
the lathe.
This section indicates the activating and setting procedures for these functions.
A few simple operations are necessary to prepare the device to handle another range of diameters.
The set-up must be modified when following parameters change:
· Bar stock diameter
· Bar stock shape
· Part length
The procedures to be followed are explained in this chapter and will be presented as concrete examples,
whenever possible.
To Next Page
Loading...
