Logicube ZClone Xi User Manual

TYPES OF OPERATIONS
Logicube ZClone™Xi User’s Manual 45
5.4.2.2 Wipe Patterns
This setting allows the user to set a specific wipe pattern or patterns to
use for wiping the drive. The number of passes is customizable (up to 7
passes) along with the type of data written for each pass. In addition, a 7-
pass DoD wipe can be set with pre-selected pass values.
There are 4 selections when setting a wipe pattern:
 MODE
 HPA/DCO
 LBAS
 PASSES
It is recommended to use the same capacity drives
per task. When smaller capacity drives are wiped
together with larger capacity drives, the smaller
drives will finish first. However, the ports will not
be available until the entire task is finished.
5.4.2.2.1 Mode
Selecting Mode will open the Wipe Mode screen
showing the following options:
 NONE – Choosing this will instruct the unit not
to perform a wipe using Wipe Mode.
 DOD – Choosing this will instruct the unit to
perform a 7-pass wipe conforming to the DoD
5220.22-M standards.
 CUSTOM – Choosing this will allow the user to
specify how many wipe passes will be performed
and what values each pass will be written on
each of the passes selected.

Logicube ZClone Xi Specifications

General

Brand	Logicube
Model	ZClone Xi
Category	Disc Duplicator
Language	English