UPDATING THE SOFTWARE AND FIRMWARE
Logicube ZClone™Xi User’s Manual 68
4. Tap the Update icon to begin the update. The unit should begin the update
process. Do not interrupt the update process. It may take several minutes. Once
completed, a screen will appear stating the update is complete and will prompt
to turn the unit off then back on.
5. Turn the unit off. Wait at least 5 seconds then turn the unit back on.
6. Verify the software version is correct by going to the Software Updates screen.
6.1.2 From USB Drive (Through a software file download)
Aside from the network option, the latest software can also be downloaded from the
Logicube website and be placed onto a USB flash drive to perform the update/re-install.
It is recommended to use an empty USB flash drive.
1. Download the latest software from the product support page at
https://www.logicube.com/knowledge/zclonexi.
2. Extract the contents of the downloaded zip file to the root of the USB flash drive.
3. Turn the unit on. When the main software screen appears, connect the USB flash
drive (that has the extracted software from step 2) to the U1 port (the front USB
port).
4. From the main menu on the unit, locate and tap the Software Updates icon on
the left side.
5. Select From USB Drive. The unit then check for the version of the software on
the USB drive. After a few seconds, one of the following messages should appear:
Software found – A software version is found on the USB flash drive. Tap
the OK icon to continue.
No new version found – The unit did not find any software on the USB
flash drive. Double-check that the correct software was downloaded and
that the files were extracted to the root of the USB flash drives (steps 1
and 2). Tap the OK icon to continue and try step 5 again or try updating
the software using the “From Network” option.
6. Tap the Update icon to begin the update. The unit should begin the update
process. Do not interrupt the update process. It may take several minutes. Once
completed, a screen will appear stating the update is complete and will prompt
to turn the unit off then back on.
7. Turn the unit off. Wait at least 5 seconds then turn the unit back on.
8. Verify the software version is correct by going to the Software Updates screen.
To Next Page
Loading...
Need help?
General