Logicube ZClone Xi User Manual

Logicube ZClone™Xi User’s Manual 83
10: Changing the default passwords
10.0 Changing the Default Passwords - Introduction
The ZXi comes with default accounts for the Command Line Interface. It is highly recommended to change
the default passwords for security purposes.
 logicube
 it
If the new password(s) cannot be remembered,
a system recovery must be performed to reset
the passwords back to the default values.
10.1 Changing Both the logicube and it Passwords
To change both the “logicube” and “it” passwords, follow these steps:
1. Connect a USB keyboard to any available USB port of the ZXi then use the following key
combinations: Alt+2 then Alt+Shift+Enter.
2. Once logicube prompt appears, type the following commands, one line at a time (Press the Enter
key after each command/line):
sudo mount -o remount,rw /
passwd
3. The following prompt will appear:
Changing password for logicube.
(current) UNIX password:
4. Type the current password for the “logicube” account (the default password for this account is
“logicube”) then press the Enter key. The following prompt will appear:
Enter new UNIX password:
5. Type a new password then press the Enter key. The following prompt will appear:
Retype new UNIX password:
6. Type the new password again then press the Enter key. The following response should appear:
passwd: password updated successfully
7. Next, type the following command:
sudo smbpasswd logicube

Logicube ZClone Xi Specifications

General

Brand	Logicube
Model	ZClone Xi
Category	Disc Duplicator
Language	English

Summary

Introduction to the Logicube ZCloneXi

Introduction to the Logicube ZCloneXi

Provides an overview of the ZClone Xi, its features, speed, and capabilities including cloning and wiping.

Getting Started with the ZCloneXi

Overview of the ZCloneXi Unit

Quick Start Guide for ZCloneXi Operations

Quick Start Guide

A basic overview of performing operations like cloning, hashing, and wiping on the ZCloneXi.

Cloning Operations

Details the process of cloning a master drive to target drives or image files.

Wipe and Format Operations

Explains how to securely erase, wipe, or format target drives using various methods.

Clone Operations in Detail

Cloning Process Overview

Explains the main cloning operation, including imaging modes and selection processes.

Cloning to Smaller Capacity Drives

Provides instructions and considerations for cloning drives to targets with smaller capacities.

Clone Settings Configuration

Updating Software and Firmware

Software Update Instructions

Provides step-by-step instructions for updating the ZCloneXi software via network or USB drive.

ZXi-Laptop Cloning Version

Requirements for Laptop Cloning

Setup Instructions for Laptop Cloning

Provides a step-by-step guide on how to set up the ZCloneXi for laptop cloning operations.

Changing Default Passwords

Changing Logicube and it Passwords

Detailed instructions on how to change both the 'logicube' and 'it' default user account passwords.

Frequently Asked Questions

ZCloneXi Frequently Asked Questions

Technical Support Information

Technical Support Contact Details

Provides contact information for Logicube Technical Support for further assistance.