Logicube ZClone Xi User Manual

UPDATING THE SOFTWARE AND FIRMWARE
Logicube ZClone™Xi User’s Manual 69
6.2 Firmware Loading Instructions
Some software releases may contain a firmware upgrade. The steps below outline how to check if there is
a firmware upgrade available:
1. After the software is updated the unit on then tap the Software Updates icon.
2. Tap the “Firmware Update” page. One of two screens will appear:
a. FIRMWARE UPGRADE AVAILABE – Tap the Update icon. A message will appear:
“FIRMWARE UPDATE COULD TAKE UP TO A FEW MINUTES TO COMPLETE; PLEASE DO
NOT INTERRUPT POWER DURING THIS TIME. ON COMPLETION THE UNIT WILL AUTO-
RESTART AND CONFIRM THE UPDATE.” Tap the OK icon to start the firmware update
process.
When the OK icon is tapped, the screen may appear to do
nothing. Do not keep tapping the OK icon. The firmware
update will take no more than 120 seconds. When the
firmware update finishes, the unit will reboot automatically.
b. FIRMWARE UPGRADE NOT AVAILABLE – This message will appear if the device does
not require a firmware update. No further action is necessary if this message appears.

Logicube ZClone Xi Specifications

General

Brand	Logicube
Model	ZClone Xi
Category	Disc Duplicator
Language	English