1.4.8
1.4.8
1.4.8
1.4.8 PROTECTION
PROTECTION
PROTECTION
PROTECTION OF
OF
OF
OF ASBESTOS
ASBESTOS
ASBESTOS
ASBESTOS DUST
DUST
DUST
DUST HAZARD
HAZARD
HAZARD
HAZARD
When the operation of machine has just
completed, temperature of hydraulic oil, oil and
water inside engine and radiator is still high, and
the pressure still exists.
At
this moment, open fuel
tank cap, radiator cap, pour oil or replace filter
are likely to cause serious burns. Therefore,
carry out those operations according to specified
procedures after the temperature dropped.
In order to prevent hot water spray out, the
engine should be close to make the water cool
down, release the pressure slowly when opening
the engine cover. (Check whether the water
temperature has reduced by testing the air
temperature with hand close to oil radiator. Be
careful not to contact with radiator.)
In order to prevent hot oil spray out, the engine
should be shut down so as to let the oil cool down ,
slowly loosen the cap to release the pressure
when opening the engine cap. (Check whether
the oil temperature has reduced by testing the air
temperature with hand close to the front of the oil
radiator. Be careful not to contact radiator.)
In order to avoid scald, do not touch relay when
the engine is hot.
Do not detach temperature sensor of engine oil,
water sensor, torque converter sensor and A/C
pipelines to avoid burnings.
Inhalation of asbestos dust may be harmful to
body health.
The products produced by LONKING Holdings
Limited do not include asbestos, but if you
contact with materials containing asbestos fibers,
please follow the below rules:
It is protective to use compressed air for cleaning .
Please use water to clean so as not to stir up the
dust.
It is dangerous if the air containing asbestos dust ,
if possible, operate the machine in the uptake.
If necessary, use qualified dust mask.
To Next Page
Loading...