EasyManua.ls Logo

Lonking CDM853 - Page 24

Lonking CDM853
153 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
23
1.4.9
1.4.9
1.4.9
1.4.9 FACE
FACE
FACE
FACE MASK
MASK
MASK
MASK AND
AND
AND
AND EARPLUG
EARPLUG
EARPLUG
EARPLUG
Never ignore the dangerous factors that may not be harmful to body health at present.
Exhaust gas and noise is unseen, but it may cause disability or permanent injury.
1.4.10
1.4.10
1.4.10
1.4.10 FIRE
FIRE
FIRE
FIRE EXTINGUISHER
EXTINGUISHER
EXTINGUISHER
EXTINGUISHER AND
AND
AND
AND FIRST-AID
FIRST-AID
FIRST-AID
FIRST-AID KIT
KIT
KIT
KIT
1.4.11
1.4.11
1.4.11
1.4.11 PREVENTION
PREVENTION
PREVENTION
PREVENTION OF
OF
OF
OF ROLLING
ROLLING
ROLLING
ROLLING INJURY
INJURY
INJURY
INJURY OR
OR
OR
OR CUT
CUT
CUT
CUT OFF
OFF
OFF
OFF
In case of personal injury or fire, please take aid
actions according to the following measures:
Fire extinguishers must be equipped. Read
carefully the instructions for use, and know how
to operate it.
First aid kit must be equipped in site, periodically
check it and timely added medicines. Know what
to do when a fire or injury happened.
Some staff s phone numbers (such as doctors,
first aid center, fire station, etc.) are well prepared ,
so that you may contact them in case of
emergency. Stick those phone numbers to a
specified place to make sure all staff are aware
of those numbers and k now the correct
communication methods.
If fire breaks out during the operation of machine,
please follow the below requirements for danger
escape: turn off the starter switch, shut down the
engine, if condition permits, take fire extinguisher
for quelling a fire. Escape from machine through
th e escalator.
It is protective to enter or place your hands or
any other body parts between movable parts,
such as between working device and oil tank and
between machine and working device. With the
movement of working device, the space of
connecting rod may increase or decrease, it may
cause serious injury accidents if you close to it.
Therefore, if you want to get close to the moving
parts of the machine first shut down the engine
and lock up working device.
Properly support equipment or accessory when
working underside the machine. Do not relay on
hydraulic cylinder for supporting. If the control

Table of Contents