1.5.7
1.5.7
1.5.7
1.5.7 CHECK
CHECK
CHECK
CHECK WHEN
WHEN
WHEN
WHEN CHANGING
CHANGING
CHANGING
CHANGING DIRECTION
DIRECTION
DIRECTION
DIRECTION
In order to prevent injury or death, even though the machine is equipped with a backup
alarm and rearview mirror, you must comply with the following rules before moving the
machine or its working devices.
Right and left glance is dangerous when
operating the machine; therefore, the operator
shall concentrate on his work.
Too
fast traveling, sudden start, sudden stop,
sudden turn or zigzag traveling is dangerous.
Adjust the height of working device below the lift
arm and keep a clearance of 500-600mm (20-
24in) from the hinge pin and ground, let the
machine travel on the level ground. Do not
operate the joystick of the working device during
running. If
it
is necess ary to operate the joystick
of working device, first stop the machine and then
If the working condition is in water condition, it
shall not exceed a permitted depth.
When passing through a bridge or private
structures, check whether their bearing
capacities can support this machine. When
walking on public road, firstly it shall be in comply
with the provisions of related authorities and
traffic laws and regulations. T he highest speed of
this loader should be lower than the normal
speed of a car. Walking in the aside road, leave
the center of the road to other vehicles.
If this machine has run at a high speed for a long
time, its tire will be overheated, and its internal
pressure becomes extremely high. It may cause
tire to blow up and produce great destructive
power, and then may cause serious injuries or
To Next Page
Loading...