Check the vicinity of the machine to ensure that there is nobody. Pay special caution to
check the back area of the machine, for this area is unclear to see from the operator ’ s
seat.
It
is necessary to designate a person to direct site traffic when the operating place is
danger or has bad visibility.
It
is not allowable to enter in the turning area or in the walking area of the machine.
Do not change direction when the machine is walking
at
high speed.
1.5.8
1.5.8
1.5.8
1.5.8 PROHIBITED
PROHIBITED
PROHIBITED
PROHIBITED OPERATION
OPERATION
OPERATION
OPERATION
1.5.9
1.5.9
1.5.9
1.5.9 PRECAUTIONS
PRECAUTIONS
PRECAUTIONS
PRECAUTIONS WHEN
WHEN
WHEN
WHEN TRAVELING
TRAVELING
TRAVELING
TRAVELING ON
ON
ON
ON THE
THE
THE
THE SLOPE
SLOPE
SLOPE
SLOPE
Be careful that the machine may dump or skid to one side when traveling on the slope.
When an emergency happens, lower the bucket to the ground to help to stop the machine .
Do not travel on grass, fallen leaves or wet steel plate surface
at
a high speed. Even a
small slope may cause the machine to skid to one side. Therefore,
it
is required to drive
Sound the horn to warn the staff and person in
In order to prevent machine upset or working
device damage due to overload, the load of the
machine must maintain within the specified
maximum value. Do not exceed the specified
capacity.
It is not allowable to dig the operation surface
beneath the upland; otherwise, it may cause the
upland collapse and smash the top part of the
machine.
It is not allowable to dig the ground deeply in
front of the machine, the collapsed soil may
cause the machine crashed.
It is dangerous to work on the soft, uneven or
cracked road, and may cause the machine
crashed. It is also dangerous to walk with
imbalanced load and non-load.
To Next Page
Loading...