4.3.4
4.3.4
4.3.4
4.3.4 PARKING
PARKING
PARKING
PARKING OF
OF
OF
OF LOADER
LOADER
LOADER
LOADER
• Drive the loader to a flat place which is free from the risk of falling stone, landslide or
flood.
• Apply the service brake to stop the loader.
• Pull the gear-shifting lever to the neutral position.
• Rotate the hand brake button to reset
it
and apply the parking braking.
• Operate the pilot joystick so as to lower the lift arm, place the bucket horizontal on the
ground and make the bucket press against the ground slightly.
• Make the engine run
at
idle speed for 5 minutes, so that all parts may cool down
evenly.
• Turn the electric lock ’ s key anticlockwise to OFF position to disconnect the control
circuit. Engine stops. Pull out the key.
• Set each switch
at
middle position or off position.
• Close the left and right doors, and then go down the stairs in accordance with the
relevant provisions.
• If the loader is to be parked for long time (for example, all the night), just open the side
door of the hood and pull the negative pole switch of battery to the off position, so as
to turn off the power supply.
• If no anti-freezing fluid is added in the coolant before the loader leaves the factory, just
open all water drain valves of the engine after parking the loader in winter, discharge
all coolant from the cooling system and the evaporator in A/C system, so a s to prevent
any part from being frozen and damaged. If the anti-freezing fluid is added when the
loader leaves the factory, please operate as indicated in the nameplate on the rear
end of the loader.
• Lock up all equipment, pull out the key and take
it
with you.
NOTE:
NOTE:
NOTE:
NOTE: Be
Be
Be
Be sure
sure
sure
sure to
to
to
to park
park
park
park the
the
the
the loader
loader
loader
loader on
on
on
on a
a
a
a flat
flat
flat
flat ground.
ground.
ground.
ground. If
If
If
If
it
it
it
it
is
is
is
is necessary
necessary
necessary
necessary to
to
to
to park
park
park
park the
the
the
the
loader
loader
loader
loader on
on
on
on a
a
a
a slope,
slope,
slope,
slope, be
be
be
be sure
sure
sure
sure to
to
to
to block
block
block
block up
up
up
up the
the
the
the wheels
wheels
wheels
wheels with
with
with
with chocks,
chocks,
chocks,
chocks, so
so
so
so as
as
as
as to
to
to
to prevent
prevent
prevent
prevent the
the
the
the
loader
loader
loader
loader from
from
from
from moving.
moving.
moving.
moving.
If
If
If
If the
the
the
the loader
loader
loader
loader is
is
is
is to
to
to
to be
be
be
be stored
stored
stored
stored for
for
for
for long
long
long
long time,
time,
time,
time, please
please
please
please operate
operate
operate
operate in
in
in
in accordance
accordance
accordance
accordance with
with
with
with the
the
the
the
following
following
following
following requirements:
requirements:
requirements:
requirements:
1. Before Storage
1) Clean up each part of the loader, dry the loader up and then store
it
in a dry
warehouse. If the loader can only be stored outdoors, be sure to park
it
on a concrete
ground where water may drain easily, and cover
it
with canvas.
2) Before storing the loader, fill the fuel tank with fuel, apply grease to each moving pin,
moving shaft and transmission shaft, and replace the hydraulic oil.
To Next Page
Loading...