any more after being inserted into the material pile, just pull backwards the joystick
with your right hand and then push
it
to the middle position, so as to lift up the bucket
for once. In this way, the bucket may go ahead for certain distance. Thereafte
r,
push
forwards the pilot joystick and then push
it
to the middle position, so as to turn
backwards the bucket for once. In this way, the bucket may get further inserted into
the material pile. Repeat the operation “ insertion, lifting, inserting and turn ing ” until
the bucket is filled with materials.
Exiting
Exiting
Exiting
Exiting from
from
from
from material
material
material
material pile
pile
pile
pile
� After the bucket is filled with materials, just operate the pilot joystick so as to turn
backwards the bucket until the stopper on the bucket contacts with the lift arm, and
then push the pilot joystick to the middle position. Now the maximum rollback ang le is
obtained.
� Raise the lift arm to a certain height, so as to ensure that the bucket may evade the
material pile when the loader is travelling backwards. Just hold the steering wheel
with your right hand, and pull backwards the gear-shifting lever to the reverse gear
position with your left hand, so as to make the loader travel backwards.
� After the loader exits from the material pile, just operate the pilot joystick so as to
lower the lift arm to the position whereby the lower linkage point of the lift arm is about
50cm above the ground.
Handling
Handling
Handling
Handling of
of
of
of materials
materials
materials
materials
� Under any of the following circumstances, the self-handling may be carried out:
① The road is soft, the place is not flattened, and
it
is impossible to use freight
vehicle.
② The handling distance is no more than 500 meters, and the use of freight vehicle
is not economical.
� In the course of handling, remain the lower linkage point of the lift arm
at
the
articulating position (about 50cm above the ground), and turn backwards the bucket
to the limit position (the stopper on the bucket contacts with the lift arm), so as to
ensu re that the handling operation may be carried out safely and smoothly and no
material will fall out.
� The speed of the loader in the course of handling operation depends on the handling
distance and road conditions. When passing any depression or crowing portion, just
release the accelerator pedal, and, if necessary, intermittently apply the service brake ,
so as to slow down the loader, make the loader pass the obstacle slowly, reduce the
impact to the loader and prevent the materials from falling down.
WARNING:
WARNING:
WARNING:
WARNING: Do
Do
Do
Do not
not
not
not lift
lift
lift
lift up
up
up
up the
the
the
the bucket
bucket
bucket
bucket to
to
to
to a
a
a
a relatively
relatively
relatively
relatively high
high
high
high position
position
position
position for
for
for
for carrying
carrying
carrying
carrying
out
out
out
out the
the
the
the handling
handling
handling
handling operation,
operation,
operation,
operation, otherwise
otherwise
otherwise
otherwise the
the
the
the loader
loader
loader
loader may
may
may
may overturn.
overturn.
overturn.
overturn.
Unloading
Unloading
Unloading
Unloading of
of
of
of materials
materials
materials
materials
To Next Page
Loading...