Lonking CDM853 - Page 96

95
① Discharging of materials into truck or hopper
� When the loader which is loaded with materials is 15 meters away from the truck or
hopper, just release the accelerator pedal, and if necessary, intermittently apply the
service brake, so as to slow down the loader and make the loader approaches the
truck or hopper at a low speed. At the same time, pull the pilot joystick backwards to
the limit position until the control handle is caught up by electromagnet, and then
release the control handle (the handle will not return to the middle position
automatical ly). The lift arm will rise continuously until it reaches the limit height, and
then the electromagnet will be de-energized, the pilot joystick will automatically return
to the middle position, and the lift arm will not rise any more. In this course, the driver
shall carefully drive the loader, carefully observe the approach by the bucket to the
truck or hopper, and may not make the bucket collide with the truck or hopper.
� When the bucket is above the truck or hopper, just push down the brake pedal so as
to stop the loader, push rightwards the pilot joystick so as to tilt forwards the bucket,
and then discharge the materials into the truck or hopper. At this time, be sure t o
carefully observe the movement of the bucket, and be sure not to make the bucket
collide with the truck or hopper. If the material is very sticky, just push and pull the
control handle repeatedly, so as to make the stopped of the bucket collide with the lift
arm repeatedly, so as to make the materials fall down from the bucket.
� If the length of the truck exceeds two times the width of the bucket, the unloading
operation shall be started with the materials on the front portion of the truck.
NOTE:
NOTE:
NOTE:
NOTE: Be
Be
Be
Be sure
sure
sure
sure not
not
not
not to
to
to
to make
make
make
make the
the
the
the stopper
stopper
stopper
stopper collide
collide
collide
collide with
with
with
with the
the
the
the lift
lift
lift
lift arm
arm
arm
arm too
too
too
too violently
violently
violently
violently or
or
or
or
too
too
too
too frequently,
frequently,
frequently,
frequently, otherwise
otherwise
otherwise
otherwise the
the
the
the loader
loader
loader
loader may
may
may
may get
get
get
get damaged.
damaged.
damaged.
damaged.
� After all materials are unloaded, just pull the pilot joystick backwards to the limit
position until the control handle is caught up by the electromagnet, and then release
the control handle (the handle will not return to the middle position automatically ).
The bucket will turn backwards continuously until it is in the horizontal position, and
then the electromagnet will be de-energized and the pilot joystick will automatically
return to the retaining position. Thereafter, just pull backwards the gear-shi fting
handle to the reverse gear position, and then release the brake pedal, so as to make
the loader leaves the truck or hopper.
� After the bucket fully leaves the truck or hopper, just lower the lift arm while the loader
the travelling, so as to get ready for the next working cycle.
② Discharging of materials at lower position
� When being handled between different places, sometimes the materials may be
discharged at lower position, which means that the materials are discharged with the
bucket located at a position close to ground. In this case, after the materials are
discharged , be sure to turn backwards the bucket until it is in the horizontal position
and then raise the lift arm, otherwise it is likely that the lift arm cannot be raised up
owing to the interference caused by the linkage of work attachment.