Why does my LORCH Welding System keep switching off?
If your LORCH Welding System switches off unexpectedly, it could be due to: * Exceeding the duty cycle. Allow the equipment to cool down at no-load. * Insufficient cooling of components. Check the air inlet and outlet on the equipment.
What to do if the inert gas feed is insufficient on my LORCH M-Pro BasicPlus Welding System?
If the inert gas feed is insufficient in your LORCH Welding System, consider these possible causes: * The inert gas quantity is set incorrectly at the pressure reducer. Adjust the setting as described in the operating instructions. * A dirty pressure reducer. Check the pressure reducing nozzle. * A blocked or leaking torch or gas hose. Check these components and replace if necessary. * Draughts blowing the inert gas away. Eliminate the draughts.
Why is the welding power reduced on my LORCH M-Pro BasicPlus Welding System?
If you notice reduced welding power in your LORCH Welding System, consider the following: * A missing phase. Try a different power socket and check the supply cable and mains fuses. * Insufficient ground contact at the workpiece. Ensure a good, clear ground connection. * The ground cable is not correctly inserted. Lock the ground connector by turning it clockwise. * A faulty torch. Repair or replace the torch.
Details on how to connect the welding torch to the machine.
Instructions for connecting the ground cable for proper electrical circuit.
Proper methods for attaching the ground clamp to the workpiece.
Step-by-step guide for loading the welding wire spool.
Instructions on how to feed the welding wire through the machine.
Procedure for connecting the gas cylinder and regulator.
General| Brand | LORCH |
|---|---|
| Model | M-Pro BasicPlus |
| Category | Welding System |
| Language | English |
To Next Page